R&V Engine Register Page

BACK TO RESTORATION PAGE
Exhaust Muffler
The muffler here was made in the USA by Lee Pederson, it is close to the orignial design. It consists of three pieces, two outer shells and a center baffle plate. Pipe thread is 1 1/2" NPT.
Outer muffler shell - same both sides	Inside of outer muffler shell	Muffler baffle plate, holes are tapered to easily extract from casting mold - taper is 1/2" to 5/8"
Square headed nut and bolts - 3/8"	Side view of complete muffler	Top view of complete muffler